Skip to main content

Ray and trendline

Bug Reports

The trendline only goes at 45 degree angles. Here is the video. The polyline works fine.. I wanted the trendline to go from wick to wick, but it went a little above the close. Here is the video https://screenrec.com/share/XmSyTtu3L0

Posted by Tradermoe ·
5 comments

Comments5

  • Serhii S.

    Team•

    Nov 15, 2024

    Hello @Tradermoe1023! Thank you for the video. To make the trend line align with the wick, avoid pressing the Shift key while drawing the line.

    • Tradermoe

      •

      Nov 16, 2024

      I was not pressing the shift key.

      • Serhii S.

        Team•

        Nov 18, 2024

        I remember that earlier you had a problem with the Shift button. Did the button get stuck this time? It looks very much like the Shift key is pressed when you move the graphics tool.

        • Tradermoe

          •

          Nov 18, 2024

          I do not use the shift key to draw lines. I will hit it if it happens again and see if that clears it up. I do not have a problem with the shift key doing anything like being stuck for anything else.

          • Serhii S.

            Team•

            Nov 18, 2024

            Thank you for the update. If the issue occurs again, please try tapping the Shift key to see if that resolves the problem.

            Additionally, let us know if you notice any other patterns or behaviors leading up to the issue, as this information will help us troubleshoot further.

            We look forward to hearing from you if the problem persists.